2 INSTALLATION AND SETUP 2 INSTALLATION AND SETUP
Create one new audio track within your new project by clicking on Project ->Add
2.6 TEST YOUR FI REBO X WIT H Track-> Audio (or you can right click (ctrl-click mac) in the track space within the
CUBASE LE project:
In order to test your FIREBOX, do the following:
Launch Cubase LE and make sure that you have selected the PreSonus FIREBOX
ASIO driver as described above in Section 2.4.
Create a new project:
Record enable the track by pressing the Record Enable button.
13 14
2 INSTALLATION AND SETUP 3 CONTROLS AND CONNECTIONS
Plug a microphone into channel one and turn on 48V phantom power if needed for the
3.1 FRONT PANEL LAYOUT AND
microphone. Turn up the channel 1 trim control on the front panel of the FIREBOX
while speaking into the microphone. You should see the input meter in the Cubase LE DESCRIPTION
track info react to your speaking. Adjust trim so that the input level is at its maximum
without clipping.
Connect a set of headphones to the FIREBOX headphone output.
Click the monitor button in Cubase LE for Audio 01 to arm the track?s monitoring.
PreSonus has also included a Cubase LE session file template on the internet at
www.presonus.com/firebox.html
1.Microphone / Instrument Pre-Amplifier. Your FIREBOX is equipped with two
Note that online help available for Cubase LE by pressing F1 or visiting
www.steinberg.net custom designed PreSonus microphone / instrument preamplifiers for use with all
types of microphones including Dynamics, Condensers, and Ribbons as well as
instruments and line level signals. The award winning PreSonus preamplifier design is
a Class A input buffer followed by a dual servo gain stage. This arrangement results in
ultra low noise and wide gain control allowing the FIREBOX user to boost desirable
signal without increasing unwanted background noise.
2. 48 Volt Phantom Power. The FIREBOX has selectable 48V Phantom power
available for both preamps.
XLR connector wiring for Phantom Power
Pin 1= GND Pin 2= +48V Pin3= +48V
+22dBu Headroom. The FIREBOX mic-pre has +22 dBu of headroom. This feature
gives you wide dynamic range and excellent transient response characteristics.
Neutrik Combo Connectors. Both preamps of the FIREBOX have a Mic/Line
connector using the Neutrik Combo connector. This revolutionary style connector lets
you use either 1? phone or XLR connectors in the same female input.
INSTRUMENT INPUTS (Channels 1 and 2): The 1? TS connector on channels 1
and 2 are for use with an instrument (guitar, bass, and etc.). When an instrument is
plugged into the instrument input, the microphone preamplifier is bypassed and the
FIREBOX becomes an active instrument preamplifier.
15 16 |
ACEC
